Not only is it always good to back up your data before doing a hardware upgrade, you can use the backup to set up your new primary storage device. Place your Unibody MacBook Pro on a soft, static-free surface. Turn the MacBook Pro upside down and discharge any static from your body by touching a piece of metal and begin removing the screws, keeping them organized as you go.
Transfer these parts over to the new drive enclosure. To swap your current hard drive, remove the two Phillips screws holding down the hard drive bracket, carefully lift the hard drive out of the MacBook Pro case, disconnect the hard drive cable and use your Torx 6 driver to remove the screws from the sides of the hard drive. Once the enclosure is in place, swap the hard drive screws over to your new storage device, attach the hard drive cable, insert the new drive into place and replace the hard drive bracket.
Step 1: Open the laptop
I'm proud to say that I'm the happy owner of an almost antique MacBook Pro. I've had this inch MacBook Pro for quite a while now and I'm not planning on changing it have you seen the price of MacBooks these days? As it is quite old now, it is not really working as well as before and my optical drive doesn't work anymore. It does not recognise any CD and keeps burping them out. It doesn't really matter as I've gotten used to it and don't use the optical drive now. I know it is possible to take it out and put an SSD in instead but what about just taking in out?go to site
And leave and empty space? What about the cables? Can they just hang in there and not be attached to anything? Yes, it is possible to remove the optical drive. However, it isn't that easy. You will need several specialized screwdrivers, a tool to remove the cables, and some manual dexterity.
If you have experience disassembling laptops it will not be a problem. It really is pretty simple as you can see in the video above or read in the detailed guide below. All you have to do is, remove the backside of the unibody.
Remove the battery connector by just slowly pulling upwards on the connector until it pops off:. Unscrew the two screws to remove the antenna module.
Optical Drives - Upgrade Your Mac
The connectors is mark by red on the following picture:. Remove connectors for HDD, optical drive, speaker and antenna module. You want to remove the bracket that holds the HDD cable in to place by unscrewing the two red-marked screws:.
- How To Swap a MacBook's Optical Drive with a Hard Drive - Tested!
- how to reformat seagate goflex desk for mac;
- Helpful answers.
- adobe photoshop cs6 mac os x tpb?
- Recommend me a replacement DVD drive for a 2008 Mac pro.